Covering the Element

Cover the element as instructed in the installation manual, taking precautions to avoid damaging the heating element. Once the element has been covered, another test should be made. Compare the results of this element test with the one taken during installation of the element. If the results don’t match the heating element should be checked for damage.

Installing the Control Units

The control units or relay panels are installed in the location selected by the customer. The installation manual and wiring diagrams provide instructions for making the connections. Once installed, the device should be tested to ensure it properly turns the system on and off. After this, the final start up and post installation tests are performed and recorded for warranty purposes. It is a good idea to meet with the client and review the operation of the system upon completion.

This is the final entry in a three part series of installation tips. Part 1 is located here. Part 2 can be found here.

For more on installing Heatizon products, including manuals and videos, visit the Installation area of our website.

The post Tips for Installers, Part 3: Final Testing and Installing the Control Units appeared first on Heatizon Systems.

Client Meeting

Before getting started, it is a good idea to sit down with the client and go over the design and application of the system. Be sure to review the location of activation devices and control units. Review the areas that are being heated and discuss any special requirements of the job.

Contractor Meeting

After meeting with the client, it is helpful for installers to meet with any other contractors involved in the project e.g., concrete and roofing contractors, electricians, flooring installers, etc. It is helpful to discuss the installation schedule, precautions that should be taken when working around the system, and any special methods or requirements that could be unusual or different for the contractors.

Layout the System

Having reviewed the design, it is important to plan the layout of the system before beginning installation. Verify both the amount of heating element required and the spacing needed to generate the required watts per square foot. For fixed length products, plan ahead to ensure all of the element can be installed evenly and with proper spacing. When installing low voltage products, verify that the system is between the minimum and maximum range for the transformer specified.

This is the first in a three part series of installation tips. Part 2 will be published next week.

For more on installing Heatizon products, including manuals and videos, visit the Installation area of our website.

The post Tips for Installers, Part 1: From Meeting the Client to Proper Layout of the System appeared first on Heatizon Systems.