M326A has blinking light, but not heating

If the M326A activator has a blinking light, but it appears that the system is not heating, follow the following steps:

  1. Make sure the SnowMeltz system/incoming power/activator are wired correctly. NOTE: M326 series activators only switch one leg of 240 volt power.
  2. Check resistance of your SnowMeltz mat to ensure it is working properly.

If the system has damage, consult the following FAQ. (Repairs)

Contact Heatizon Systems for more help. 888-239-1232

Damaged/Cut SnowMeltz Mat

Please note, DO NOT attempt to cut or shorten the SnowMeltz mat in order to fit into a smaller area.

If a SnowMeltz mat is accidently cut/damaged BEFORE it is embedded, call Heatizon (888-239-1232) for information about obtaining a repair kit.

If the SnowMeltz mat has been damaged and is already embedded, but the location of the damage is unknown, Heatizon has developed a process to locate the approximate location of the damage. Contact Heatizon to learn about this method (888-239-1232). Please note, this method has two stipulations:

1. A layout of the SnowMeltz mat for how it is installed.

2. If there is more than one damaged area, only one repair can be done at a time.

Damaged SnowMeltz Mat

Should you need to repair a SnowMeltz mat that has been cut and/or damaged, please contact Heatizon systems, for instructions. 888-239-1232